Publicité
Les langues disponibles
Les langues disponibles
Assembly
1. Remove unit from packaging and place on level surface with
unit laying down. FIG 4
2. Remove all hardware from box and layout out for assembly
process. FIG 5
3. Assemble the 2 front caster wheels FIG 6: Insert the threaded
portion of the caster through the hole in the leg as shown.
Install flat washer and nut. While holding the caster with the
wrench provided, tighten nut with a 19 mm wrench
(not included).
FIG 4
4. Assemble the rear 2 wheels with flat washer and cotter pin:
Using pliers, bend the longer leg of the cotter pin back to
prevent it from falling out.
5. Stand the unit up on its wheels. Unlatch the lid and open fully
to access the filter assembly (No tools required). Remove the
filter assembly by holding the handles and tilt at an angle and
pull up and out. FIG 8
FIG 5
6. Set filter assembly aside. Remove the handle, suction screen
and hoses located inside tank. FIG 9
FIG 8
7
FIG 6
FIG 7
FIG 9
Publicité
