LED2WORK TUBELED40 II RGB-W Manuel D'utilisation page 10

4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no signs of damage. Do not use the
luminaire or accessories if they are damaged, as there is a risk of injury.
The LED luminaire comes fully assembled. The luminaire is intended for mounting in optional luminaire holders or mount-
ing angles. As option there are this mounting accessories:
TUBELED_40 II luminaire holder, Aluminium, pair
TUBELED_40 II luminaire bracket, VA, pair, luminaire infinitely adjustable 110°
TUBELED_40 II luminaire bracket, VA, pair, with magnet
TUBELED_40 II Luminaire holder, VA, 1 pair, luminaire adjustable ± 180°
5 | Connection
Suitable connection material, cables and accessories can be found in the accessory range of LED2WORK.
PIN assignment of the M12 connector is as follows:
PIN allocation
PIN 1 = 24V DC
PIN 2 = 24V DC
PIN 3 = GND
PIN 4 = 24V DC
PIN 5 = 24V DC
10 | BA TUBELED_40 II RGB-W . BA 11/2022
When mounting the luminaire, make sure that the luminaire is fastened securely and
stably. If the luminaire falls down, its weight poses a risk of injury!
Schematic drawing of M12 plug
LED colour: green
LED colour: blue
LED colour: red
LED colour: white
Further colours can be displayed by gating two or three PINs simultaneously. Do not
operate the white light colour simultaneously with the coloured light channels.
Get in touch with us for more information.
The luminaire is not equipped with a ON/OFF switch. Usually you switch the luminaire ON
or OFF via external switches of machines or systems.
Product no.
210200-06
210200-11
210200-12
210200-14