EINHELL FREELEXO 800 LCD BT Instructions D'origine page 33

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
Explanation of the symbols used (see Fig. 14)
A. WARNING - Read the operating instructions
before you start using the machine.
B. WARNING - Keep a safe distance away from
the machine when it is in operation.
C. WARNING - Always actuate the locking me-
chanism before carrying out any work on the
machine or before lifting the machine. CAUTI-
ON - Do not touch rotating blades!
D. WARNING - Do not ride on the machine.
CAUTION - Do not touch rotating blades!
E. Protection class II (double-insulated)
F. Store the battery only in dry rooms with an
ambient temperature of +10°C to +40°C.
Place only charged batteries in storage (char-
ged at least 40%).
G. Switch mode power supply unit
H. Protection class III
I. Slow fuse 3.15 A
J. Isolating transformer with protection against
short-circuits
K. For use in dry rooms only.
Important!
Always pull out the power plug and disconnect
the perimeter wire from the charging station du-
ring a storm.
Anl_FREELEXO_LCD_BT_SPK9.indb 32 Anl_FREELEXO_LCD_BT_SPK9.indb 32
GB
2. Layout and items supplied
2.1 Layout (Fig. 1/2)
1. Robot lawn mower
2. Control panel
3. STOP button / release button for the display
cover
4. Cutting height adjustment facility
5. Rain sensor
6. Carry-handle
7. Main switch
8. Rear wheel
9. Battery compartment cover
10. Blades
11. Blade plate
12. Front wheel
13. Power supply unit (cable)
14. Fastening peg
15. Fastening screw
16. Cable connector
17. Spare blades
18. Perimeter wire
19. Charging station
20. Charging pin
21. LED indicator
22. Rechargeable battery
23. Charger
24. Display cover
25. Hexagon key
26. Ruler (for detaching)
2.2 Items supplied and unpacking
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 32 -
30.03.2021 13:29:01 30.03.2021 13:29:01