Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.2 FUNCTION OF THE INDICATORS
INDICATOR
CHARGE
5. DESCRIPTION OF THE LCD DISPLAYS
WEIGHT DISPLAY
The weight on the plate is shown in this display.
A
P
W
VERAGE
IECE
EIGHT
The entered or calculated average piece weight is shown in this display.
COUNT DISPLAY
The current number of pieces is shown in this display.
FUNCTION OF THE SYMBOLS
The LCD displays have symbols which show the indicator's functioning status; you will find the description for each symbol
below.
SYMBOL
Indicates that the battery is low (see section 3.2)
W1
The instrument is in the first weighing range.
W2
The instrument is in the second weighing range.
NET
Indicates that the displayed weight is a net weight.
~
The weight is unstable.
Indicates that the weight detected by the weighing system is near zero.
0
LOW-PCS
Indicates that there are an insufficient number of samples in order to determine an accurate count (see
section 6.5).
LOW-APW
Indicates that the average piece weight is insufficient in order to determine an accurate count (see section
6.5).
M+
Indicates that the total weight is greater than 0.
6. OPERATION
6.1 AUTOMATIC ZERO UPON START-UP
The indicator has an "auto zero at start-up" function: in other words it means that if at start-up a weight within + / - 10%
of the capacity is detected, it will be zeroed; if the weight is not within this tolerance, the display shows "Err 4" and with
a non approved instrument the present weight after a few instants, while with an approved instrument "Err 4" is shown
continuously.
6.2 SCALE ZERO
You can press the ZERO key at any time to set the zero point from which all other weighing and counting is measured,
within + / - 2% of power up zero. This will usually only be necessary when the platform is empty. When the zero point
is obtained the display will show the indicator for zero.
Indicates that the battery is going to recharge (see section 3.2).
DISPLAY
FUNCTION
FUNCTION
7
Publicité
Chapitres
Table des Matières
