probst FTZ-MAXI-25 Instructions D'emploi page 42

Adjustments
5.2 Adjustment of the height adjustable support (accessory)
When using the device in batch operation, for gripping of single stone slabs (batched one upon the other),
we advise to use the accessory "height adjustable support" HVA-FTZ/TSZ (see figure).
Therefore, the inside height must not always be adjusted again for gripping goods with the same
dimensions.
When picking up in batch operation the top stone slab may
only be lifted!
•
The height adjustable support (B) is attached to the
mounting plate (A)
•
Adjust the height adjustable support (B) with the
adjusting screws and make sure that both parts have the
same height and that the rubber gripper bars are
positioned in the middle area of stone thickness.
Caution while adjustment work. There is danger of injuring the hands!
Use safety gloves! →
53100344 14 / 20
Abb. 1
GB