Whirlpool WFW95HEDW Guide D'utilisation Et D'entretien page 12

Using Your Washer
10.
Select any additional options*
Appearance may vary.
To add an option to the cycle, touch its name – Steam Clean,
EcoBoost option, FanFresh
™
Signal, or Control Lock. To remove an option from the selected
cycle, touch the option again.
11.
Setting a delayed wash
If you do not want to begin a cycle immediately, you may
choose the DELAY WASH option. This will delay the start
of the wash cycle by up to 12 hours.
To set a delayed wash:
1. Touch DELAY WASH + and – buttons to set the desired
delay time.
2. Touch and hold START to set the delay. The delay
countdown has started when the START light stops blinking.
12.
ouch and hold START to begin
T
wash cycle
Touch and hold START to start the wash cycle. To pause a
cycle in progress, touch START once, then touch and hold
again to continue the cycle. To cancel a cycle, touch POWER.
Once you touch and hold START, you will hear the door lock,
unlock, and lock again. The washer door will remain locked
during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add Garment" light is lit.
Touch START once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold START again to
restart the cycle.
12
/TumbleFresh , Extra Rinse, Cycle
® ™
13.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has
completed to avoid odor and rusting of
metal objects on garments. When unloading
garments, pull back the door seal and check
for small items between the tub and the washer drum.
If you will be unable to remove the load
promptly, use the FanFresh
option (depending on model). If selected,
the FanFresh option will activate the fan and
®
tumble the load periodically for up to 12 hours.
The TumbleFresh option will tumble the load
™
periodically for up to 6 hours. To turn off the
FanFresh or TumbleFresh
® ™
POWER. To set the washer so that the FanFresh
TumbleFresh option does not come on for future cycles,
™
touch FanFresh or TumbleFresh.
NOTE:
The door will remain locked while the FanFresh
n
TumbleFresh option is active. To cancel the option and
™
unlock the door, touch POWER.
n A small amount of water may remain in the dispensers after
the wash cycle is complete. This is normal.
n This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry
between uses.
* Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.
or TumbleFresh
® ™
option, touch
/
®
/
®
OR