LG WM1388HW Manuel Du Propriétaire page 15

Connecting the Drain Line
Secure the drain hose in place to prevent moving
and leaking.
NOTE
The drain hose should be properly secured.
y
Failure to properly secure the drain hose can
result in flooding and malfunction.
Total height of the hose end should not exceed
y
96 inches (244.8 cm) from the bottom of the
washer.
The drain must be installed in accordance with
y
any applicable local codes and regulations.
Make sure that the water lines are not
y
stretched, pinched, crushed, or kinked.
Using a Standpipe
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10
cm) of the end of the drain hose. If the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold or
microorganisms could spread to the inside of
the washer.
Elbow bracket
2
Insert the end of the drain hose into the
standpipe.
3 Use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
Using a Laundry Tub
1 Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10
cm) of the end of the drain hose. If the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold or
microorganisms could spread to the inside of
the washer.
Elbow bracket
2 Hang the end of the drain hose over the side of
the laundry tub.
3 Use a tie strap to secure the drain hose in place.
INSTALLATION
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
15