Publicité
Les langues disponibles
Les langues disponibles
36
SPECIFICATIONS
Problem
Wrinkling
Power will not turn on
The door does not open
when the cycle pauses
or finishes
The wash cycle time is
longer than usual
It is musty or moldy in
the tub
Banging noise when
washer is filling with
water (Water Hammer)
Possible Causes
Did you remove the load
y
immediately after it finished?
Did you overload the tub?
y
Did you reverse the hot and cold
y
water inlets?
Is the power cord plugged in
y
properly?
Has a house fuse blown, a circuit
y
breaker tripped, or a power outage
occurred?
Is the temperature in the tub too
y
high?
Is the water level in the washer
y
high?
Is the washing machine overloaded?
y
Are other options added to the wash
cycle?
Has the incorrect detergent been
y
used?
Did you clean the tub periodically?
y
Plumbing in the home moves or
y
flexes when the water valves in the
washer shut off.
Household water supply pressure is
y
very high.
Solutions
Remove the load immediately after
y
it finishes.
Do not overload the tub.
y
Hot water rinse can cause garments
y
to wrinkle. Check the inlet hose
connections.
Make sure that the plug is secured
y
in a grounded 3-prong, 120 V (60 Hz)
outlet.
Reset the circuit breaker or replace
y
the fuse. Do not increase the fuse
capacity. If the problem is a circuit
overload, have it corrected by a
qualified electrician.
The washing machine has a safety
y
lock built into the door to prevent
burning. Leave the door closed
and wait until the door lock icon
disappears from the display.
Allow the washer to complete the
y
programmed cycle, or press the
SPIN button.
This is normal. The washing
y
machine automatically adjusts the
cycle time for the amount of laundry,
water pressure, water temperature,
and other operating conditions.
Use only HE (High-Efficiency)
y
detergent recommended for a front-
loading washing machine.
See page 29, clean the inside and
y
outside of the washing machine
periodically.
Water hammer is not caused by a
y
defect in the washer. Install water
hammer arrestors (purchased
separately at hardware or home
improvement store) between the fill
hose and the washer for best results.
Adjust household water supply
y
regulator to a lower pressure
or contact a plumber to have a
regulator installed.
Publicité
