Télécharger Imprimer la page

AEG FSE62800P Notice D'utilisation page 47

Masquer les pouces Voir aussi pour FSE62800P:

Publicité

Les langues disponibles

Les langues disponibles

Problem and alarm code
The appliance trips the cir-
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
12.1 The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
Possible cause and solution
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian-
ces in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and the basket
loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and the filter. Refer to "Care and
Cleaning".
• Tableware has been left for too long inside the closed
appliance.
• There is no rinse aid or the dosage of rinse aid is not
sufficient. Adjust the rinse aid level to a higher level.
• Plastic items may need to be towel dried.
• For the best drying performance, activate XtraDry and
AirDry.
• We recommend to always use rinse aid, even in com-
bination with multi-tablets.
• The released quantity of rinse aid is too high. Adjust
the rinse aid level to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
ENGLISH
47

Publicité

loading