Replacing the bulb
CAUTION:
Do NOT remove the LED lighting cover!
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING:
The LED light is very bright and can damage the
eyes. Never look directly into the LED light!
Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns!
NOTE:
Order the lamps from your dealer or in our online
accessories shop www.bomann-germany.de.
Lamp data: LED max. 1 x 2.0 W, AC 12 V,
ILCOS D Code acc. EN 61231: DBS-2/30-H-120-33
Remove the grease filter(s).
(a) or (b):
Open the black protective box of the
plug-in device and release the plug connection.
Carefully push the lamp out of the holder through
the housing.
Replace defect LED module and connect the two
ends of the plug-in device.
Insert new lamp properly in the bulb holder.
Close the protective box with inserted plug-in
device. Replace the grease filter(s).
Depending on model
Troubleshooting
Before you contact an authorized specialist
Problem
Possible Cause / Solution
Unit is not
- Check the power supply.
working or
- Check the power level.
not properly
Unit is not
- Check the power level.
working
- Is the kitchen properly ventilat-
efficiently
- Clean the grease filter(s).
- At recirculation mode, check the
- Check the air outlet.
Light is not
- Check the bulb, see
working
Oil is drip-
- Clean the grease filter(s).
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
Technical Data
Electrical connection............................................
Connection voltage: ..................220-240 V~ / 50 Hz
Connection power: ........................................62 W
Lighting, LED: .......................................1 x 2.0 W
Protection class: ...............................................I
Weight / Dimension in mm.....................................
Net weight: .....................................approx. 8.0 kg
43
ed?
carbon filter.
"Replacing
the bulb".