Electrolux WS140SLMB Manuel Utilisateur page 48

48 WWW.ELECTROLUX.COM
•
The electric system must be equipped with a means
for disconnection, with a contact separation in all
poles
overvoltage category III.
•
If a plug is used for the electric connection, then it
must be accessible after installation.
•
The connection should include correct earthing, in
compliance with current norms.
•
WARNING! Before connecting the appliance
compare the power data (voltage and frequency)
indicated on the characteristics plate with those of
the power supply in question. If these data do not
match there may be problems. In case of doubt,
contact an electrician.
•
WARNING! If the electrical wire plug is removed,
the appliance must be installed and connected by a
technician. Contact a qualified electrician who knows
and
manufacturer
damage resulting from fitting or connecting errors.
•
WARNING! The electrical safety of the appliance
can only be guaranteed if it is earthed. The
manufacturer
damage resulting from the absence of or defects in
the installation's protection system (e.g. electrical
shock).
•
WARNING! Only use the appliance once it has
been fitted into its built-in position. Only in this
manner can it be guaranteed that users cannot
access the electrical components.
•
WARNING! Never open up the appliance's
frame. Possible contacts with electrical conducting
that provides
respects current
cannot
cannot
full disconnection
safety standards.
be held responsible
be held responsible
under
The
for
for