Weller WXUP Traduction De La Notice Originale page 14

EN
ENGLISH
Read these instructions and the accompanying
safety information carefully before starting up
the device and starting work with the device.
Failure to observe the safety regulations results in a risk to
life and limb.
Keep these instructions in a place that is accessible to all
users. Please adhere to the operating instructions of the
connected devices.
Please be sure to read and follow the operating instructions
for your Weller Supply Unit.
Safety information
For safety reasons, children and youths
under the age of 16, as well as per-
sons who are not familiar with these
operating instructions, may not use the
device. Children should be supervised
in order to ensure that they do not play
with the tool.
This device is not intended for use by
persons (including children) with limited
physical, sensory or mental aptitude,
or by persons who lack knowledge or
experience in handling the device.
Always place the soldering tool in the
safety rest while not in use.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
Use only original Weller soldering
tips!
WARNING Electrical shock
Protect yourself against electric shocks. The handles
on soldering tools with an antistatic design are conductive.
Avoid touching earthed objects such as pipes, heaters,
•
cookers and refrigerators.
Do not use the soldering tool in a damp or wet
•
environment.
Never work on voltage-carrying parts.
•
10
WARNING Risk of burns
The soldering tip becomes very hot during soldering
work. There is a risk of burns from touching the tips.
After the soldering process, the soldering tool and
the workpiece holder are still hot.
Always place the soldering tool in the safety rest while
•
not in use. Make sure the safety holder is stable.
Do not touch the hot soldering tips and keep them away
•
from inflammable objects..
Only replace solder tips when cold
•
Only replace nozzles when cold
•
Risk of burning through liquid solder. Protect yourself
against solder splashes.
Wear appropriate protective clothing to protect yourself
•
against burns. Protect your eyes by wearing eye
protection.
When working with adhesives, special attention must be
•
paid to the warning information provided by the
adhesive manufacturer.
Only connect the vacuum and hot air at the
•
designated points.
WARNING Fire hazard
Covering the soldering iron or the safety holder poses
a fire hazard. Always keep objects well away from the
soldering iron and safety holder.
Always keep objects well away from the soldering iron
•
and safety holder.
Keep all combustible objects, liquids or gases well away
•
from the hot soldering tool.
Do not place or leave the hot soldering or desoldering
•
tip on the worktop or on plastic surfaces.
Avoid unintentional operation. Disconnect the
•
soldering tool from the power supply while not in use.
Keep explosive and flammable objects well away from
•
the device.
Store your soldering tool in a safe place. When not in use,
units and tools should be stored in a dry, high or locked area
out of the reach of children. Make sure that unused soldering
tools are free of voltage and de-pressurised.
Do not use the cable for purposes other than those for
which it is intended. Never carry the unit by the cable. Do
not use the cable to pull the plug out of the socket. Protect
the cable against heat, oil and sharp edges.
Be alert. Pay attention to what you are doing. Be smart
when using the unit. Do not use the soldering tool if you are
having difficulty concentrating.
Avoid abnormal posture. Arrange your work station in an
ergonomically correct way. Avoid bad posture when using the
unit, as this can lead to postural problems.