Brita PURITY 1200 Clean Instructions De Remplacement page 8

•
•
•
•
•
6 Commissioning
Note: A bucket with a minimum capacity of 10 litres is needed for flushing/bleeding.
•
•
•
•
•
10 L
•
7 Technical Data
Operating pressure
Water intake temperature
Ambient temperature for storage/transport
8 Order numbers
PURITY 1200 Clean filter cartridge
PURITY 1200 Clean Extra filter cartridge
Check the connector seat of the filter cartridge O-ring
lid for dirt and damage.
3
Place new filter cartridge
Stand on the kick loops
turning clockwise until the mantle handles
Stand on the kick loops
vessel lid on the pressure vessel
3
on the lid handle must line up with the "INSERT" groove.
14
Press the pressure vessel lid
engages .
8
Place the bucket under the flush hose and open the flush valve
Open the inlet valve
6
bucket. Flush with at least 10 litres.
Close the flush valve
16
Check system for any leaks.
Note the next exchange date on the enclosed sticker (PURITY 1200 Clean:
light blue sticker, PURITY 1200 Clean Extra: red sticker) and attach it to the
Service Pass on the pressure vessel
Note: Do not stick over the top sticker with the installation date.
Switch the power supply to the appliance on.
in the pressure vessel
2
with both feet; lift the pressure vessel
9
11
with both feet and place the pressure
9
. The positioning of the arrow marking
1
down and turn clockwise until the lock
3
on inlet hose while holding the flush hose in the
5
and empty the bucket.
.
1
in the pressure vessel
2
.
1
1
are over the kick loops
.
16
2 bar to max. 6 bar
+4 °C to +60 °C
–20°C to +50°C
Article number
315645
1008197
whole
.
9
EN
7