Krick RoMarin Antje Mode D'emploi page 41

Fig. gluing on sliding hatch
Glue on the sliding hatch is the last wooden part.
Now prime the companionway with pore-filler,
sand and then varnish with clear lacquer.
Now glue on the door knob, handle and slide rail.
Slide rail
3.54
Fig. companionway with fittings
Door knob
3.53
Fig. door handle companionway
Now the rear hatch and loading hatch are still
missing.
First the rear hatch. To do this, carefully tape the
coaming edge and the deck with Tesa. Coat the
corresponding ends with wood glue and staple
parts 3.39 and 3.40 to the coaming edge to dry.
The adhesive tape prevents the frame from stick-
ing to the deck and the coaming edge. Finally glue
the cover 3.41 on.
Stand Mai 2019
M
T
.com
Handle 3.52
Seite 13
Handles
3.42 and 3.43
Fig. cover for hatch in the stern
Finally, finish the loading hatch. Glue parts 3.55
and 3.56 together to form the frame and then glue
part 3.57 on as hatch cover.
3.57
3.55
Fig. loading hatch
After staining, priming and varnishing make the
handles from the eyebolts and rings.
3.59
Fig. handles of the loading hatch
©
Krick Modelltechnik Knittlingen
3.41
3.39
3.40
3.56
3.58