Publicité
Les langues disponibles
Les langues disponibles
Blower
The blower function can be used to remove debris from
behind small spaces, to dry a damp floor, to blow grass
clippings or leaves from an outside walk, patio, etc.
To Use as a Blower (Fig. A, G)
1. Empty the tank following the instructions under the Dry
Vacuum Cleaning section of this manual.
2. Twist the vacuum hose
from the intake port.
3. Align the hose end
13
ensuring the hose alignment lock
arrow
above the side exhuast port.
15
4. Insert the hose end into the side exhaust port and twist
clockwise to lock in place.
Fig. G
Hose and Accessory Storage
When the vacuum is not in use, remove the battery pack.
The vacuum hose can be wrapped around appliance,
underneath the battery interface, and secured with the
hose clip
9
also located at the back of the vacuum. The two
accessories (crevice tool and wide nozzle) can be stored on
board the vacuum as well.
MAINTENANCE
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Lubrication
Never lubricate the vacuum motor. The motor bearings are
permanently sealed. This vacuum is intended for indoor
use and for wet or dry pick up, but it is not intended to be
exposed to rain.
8
counterclockwise to remove
with the side exhaust port
is aligned with the
14
15
13
To reduce the risk of
Accessories
WARNING:
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
,
10
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Repairs
The charger and battery pack are not serviceable. There are
no servicable parts inside the charger or battery pack.
WARNING:
RELIABILITY, repairs, maintenance and adjustment
14
(including brush inspection and replacement, when
applicable) should be performed by a CRAFTSMAN
factory service center or a CRAFTSMAN authorized
service center. Always use identical replacement parts.
To find the nearest service center, please contact
CRAFTSMAN, call 1-888-331-4569.
Cleaning
WARNING:
air vents with clean, dry air at least once a week. To
minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.
WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.craftsman.com/registration
English
Since accessories, other than
To assure product SAFETY and
Blow dirt and dust out of all
Never use solvents or other
9
Publicité
