FITFIU FITNESS MC-160 Manuel D'instructions page 52

TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
Treadmill does not start
Running surface slips
Belt wobbles when
stepped on.
Belt is not centred.
STORING
FOLDING
Unscrew the safety lock nut on the lower frame and the lock nut on the column, fold the treadmill and pull the spring
knob from the left vertical position and release it to lock the treadmill in the vertical position.
In order not to lose the safety lock, screw the armrest safety lock nut onto the upright column, and screw the upright
position lock nut onto the lower and upper frame.
Cause
The treadmill is not plugged in.
The safety key is not correctly
installed.
The fuse in the box has tripped.
La superficie no está
suficientemente tensa.
Insufficient lubrication has been
applied to the running surface.
Belt is too tight.
Belt tension is not even on the rear
roller.
Connect the plug to the electrical socket.
Reinstall the safety key.
Wait 5 minutes and then try to restart the
treadmill.
Adjust the running surface tension.
Apply lubricant.
Adjust the belt tension.
Centre the belt.
52
Solution