Publicité
Les langues disponibles
Les langues disponibles
CROSSOVER SELECTOR CONTROL (Channel 2 mids/highs) (17)
This allows users to choose their desired crossover points for the high side of the mids and the highs for
channel 2.The control range is between 80 Hz and 900 Hz or 800 Hz and 9 kHz, depending on the position
of the Range switch.
RANGE (x10) SWITCH (Channel 2 mids/highs) (18)
This switch multiplies the value indicated on the Crossover Selector control for the high side of the mids and
the highs times 10.When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. Range x10
is indicated by the illumination of the red LED above the switch.
LOW GAIN CONTROL (Channel 2) (19)
This controls the output level of the channel 2 low frequency signal (signal below the selected low/mid
crossover point) present at channel 2 low output XLR.
MID GAIN CONTROL (Channel 2) (20)
This controls the output level of the channel 2 mid frequency signal (signal above the selected low/mid
crossover point and below the selected mid/high crossover point) present at channel 2 mid output XLR.
HIGH GAIN CONTROL (Channel 2) (21)
This controls the output level of channel 2 high frequency signal (signal above the selected mid/high crossover
point) present at channel 2 high output XLR.
OUTPUT MUTE SWITCHES (Channel 2) (22)
This mutes the output of the associated level controls.The Mute function will be indicated by the illumination
of the red LED located above the associated switch.
POWER SWITCH (23)
This 2-position rocker switch applies mains power to the unit when in the ON position. Power ON is
indicated by red LED located above of the Power switch.
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
18
22
17
19
20
21
23
Publicité
