Peavey PV 35XO Mode D'emploi page 10

10 12 14 16
8 9
11 13 15
MID GAIN CONTROL (Channel 1) (8)
This controls the output level of the channel 1 mid frequency signal (signal above the selected low/mid crossover
point and below the selected mid/high crossover point) present at the channel 1 mid output XLR.
HIGH GAIN CONTROL (Channel 1) (9)
This controls the output level of the channel 1 high frequency signal (signal above the selected mid/high crossover
point) present at the channel 1 high output XLR.
OUTPUT MUTE SWITCHES (Channel 1) (10)
This mutes the output of the associated level controls.The Mute function will be indicated by the illumination of
the red LED located above the associated switch.
MODE SWITCH (11)
This switch selects between stereo 3-way operation and mono 5-way operation.The red LED above the Mode
switch indicates mono mode.When this switch is engaged, the crossover is in mono operation.
SUBS OUT SUMMED SWITCH (12)
This switch combines the sub frequencies of both channel 1 and channel 2 into a single output, which allows you to
use half as many amplifiers as you would with two channels of subs.The Summed function will be indicated by the
illumination of the red LED above the switch.
INPUT GAIN CONTROL (Channel 2) (13)
This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2.The
control range is between -12 dB and +12 dB.
CLIP INDICATOR (Channel 2) (14)
When illuminated, the red Clip indicator located to the upper right of the Input Gain control indicates that the
signal is clipping.This clipping may be heard as distortion.While there should be no problem if this indicator flashes
occasionally, it should never flash constantly or stay illuminated.This could result in impaired system performance
and possible loudspeaker damage.
CROSSOVER SELECTOR CONTROL (Channel 2 lows/mids) (15)
This allows users to choose their desired crossover points for lows and the low side of the mids for channel 2.The
control range is between 80 Hz and 900 Hz or 800 Hz and 9 kHz, depending on the position of the Range switch.
RANGE (x10) SWITCH (Channel 2 lows/mids) (16)
This switch multiplies the value indicated on the Crossover Selector control for the lows and the low side of
the mids times 10.When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. Range x10 is
indicated by the illumination of the red LED above the switch.