Dometic PERFECTVIEW CAM360 Instructions De Montage page 23

CAM360
Proceed as follows:
➤ Temporarily position the cameras using adhesive strips or suction cups as shown
in fig. 9, page 6 to fig. b, page 6.
➤ Temporarily connect the camera system according to the circuit diagram
(fig. c, page 7).
➤ Perform a basic calibration as a test (refer to chapter "Calibrating the 360° view"
on page 33).
➤ Mark the positions of the cameras.
Securing the cameras
A
NOTICE!
• Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
• Deburr all drill holes that have been made in the sheet metal and
apply rust-protection.
• Place a cable sleeve in all sharp edged ducts.
Observe the following mounting instructions:
• The most secure type of attachment is with screws fitted through the body.
Please observe the following instructions:
– There must be sufficient space behind the chosen installation location to be
able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any
holes made (e.g. by using screws and sealant and/or spraying the outer
attachment parts with sealant).
– The location on the body where you wish to attach the camera must be rigid
enough to allow the camera to be tightly fastened.
• Check beforehand whether electrical cables can be damaged when the drill
passes through the material (fig. 2, page 4).
• If you are not sure about the location you have chosen, ask your vehicle manufac-
turer or dealer.
EN
Installing the video system
23