EINHELL LE-PTK 800 Mode D'emploi page 14

Anleitung LE-PTK 800 SPK 1
GB
immediately after completion of any repairs or
maintenance.
It is imperative to observe the manufacturer's
safety, operating and maintenance instructions
as well as the dimensions quoted in the
technical data.
It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
Note the information published by your
professional associations (VBG 7j).
Switch on the dust extraction system each time
you use the machine. The operator must be in-
formed about the conditions which influence the
release of dust, e.g. the type of material being
worked (how it is held and source), the impor-
tance of local separation and the correct
positioning of hoods/guidance plates/guidance
arrangements.
Use the saw only with a suitable vacuum
extraction system or a standard industrial
vacuum cleaner.
Never use the cable for any purpose other than
that for which it is intended!
Never remove loose splinters, chips or jammed
pieces of wood when the saw blade is running.
To rectify faults or remove jammed pieces of
wood, always switch off the machine first. - Pull
out the power plug! -
If the sawing gap is worn, replace the table insert
(6). - Pull out the power plug! -
The bench-type saw has to be connected to a
230 V socket-outlet with earthing contact and
minimum fusing of 10 A.
Never use tools or attachments with insufficient
power for the job in hand.
Never use tools on jobs for which they were not
intended!
Make sure you stand squarely and keep your
balance at all times.
Check the tool for possible damage!
Each time before re-using the tool, carefully
check that the guards or any slightly damaged
parts are working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
Unless otherwise stated in the operating
instructions, damaged guards and parts have to
be repaired or replaced by an authorized service
center.
Have damaged switches replaced by a customer
service workshop.
This electric tool complies with the pertinent
safety regulations. Repairs are to be carried out
14
12.11.2004 9:21 Uhr Seite 14
only by a qualified electrician using original
replacement parts or the user may suffer an
accident.
Wear suitable protective equipment and clothing
if necessary. This may include the following:
-Wear ear-muffs to protect your hearing.
-Wear a breathing mask for protection against
breathing in hazardous dust.
-Wear gloves when handling saw blades and
materials with rough surfaces. Always carry saw
blades in a holder whenever practicable.
Caution! Risk of injury! Do
not reach into the running
saw blade.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E DIN EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
for the user (ear-muffs).
Cutting
Sound pressure level LPA 86,8 dB(A)
Sound power level LWA 99,8 dB(A)
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
Idling
76.0 dB(A)
89.0 dB(A)