Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
TIMER
Auto Off
1. When the air conditioner is turned on, press the
timer button to activate the auto off timer.
2. Press the temperature control buttons to change
the set time in 0.5 hour increments up to 10
hours and then in 1 hour increments up to 24
hours.
Auto On
1. When the air conditioner is turned off, press the
timer button to activate the auto on timer.
2. Press the temperature control buttons to change
the set time in 0.5 hour increments up to 10
hours and then in 1 hour increments up to 24
hours.
Using Auto On and Auto Off Together
The auto on and auto off timers can be used at the
same time by fi rst setting one and then the other.
For example, if the air conditioner is running,
you can set the auto off timer to let it run for a set
amount of time before turning off and then set the
auto on timer to turn it back on at a later time.
Or, if the air conditioner is not running, you can set
the auto on timer to turn it on at a later time and
then set the auto off timer to shut it off after running
for a period of time.
Note: The timer will not cycle the air conditioner on
and off indefi nitely. The auto on and auto off timers
will function one time and then the air conditioner
will return to regular functioning.
Turning the air conditioner on or off at any time
or changing the timer setting to 0.0 will cancel the
timer settings.
FOLLOW ME
There is a temperature sensor built into the remote
control that will continuously collect the current room
temperature. Keep the remote control with you and
the air conditioner will automatically adjust the set
temperature based on the ambient temperature
where you are located.
Press the follow me button to activate. The remote
will display the current temperature at its location.
The remote will send a signal to the air conditioner
every 3 minutes, so long as you remain within
range. The maximum distance for the follow me
feature is 8 meters (26 feet). This feature is available
in cool and auto modes.
The follow me light on the control panel will
illuminate for 5 seconds every three minutes to
indicate that it has received a signal from the
remote. If the air conditioner does not receive a
signal from the remote during any 7 minute interval,
it will beep to indicate that follow me has ended.
SLEEP
The sleep feature can be used to conserve energy
during sleeping hours. The sleep feature can be
canceled at any time by pressing the sleep button.
When selected, the set temperature will increase
by 1°C/2°F every 30 minutes for one hour. The air
conditioner will hold the new set temperature for
6 hours before automatically returning to normal
operation.
WIRELESS CONNECTION
This appliance can be controlled with a wireless
application on your wireless device.
Visit https://www.danby.com/support/apps to
download the application and learn about its
operation.
15
Publicité
