Supplies Required - Bradley S19-310PVC Manuel D'installation

Installation
Installation
NOTICE! Avoid cleaners containing organic solvents,
alcohols, and hydrocarbons. Rinse with water after
cleaning.

Supplies Required:

• (4) ⁵⁄₈" floor anchors and bolts
• PVC compatible pipe sealant and teflon tape
• Piping to 2" PVC water supply inlet on unit
• Piping to 2" PVC drain outlet for eye wash on unit
• Adequate supply pipe supports
• Minimum 4" (102mm) drain to accommodate 30 gallons
per minute discharge for drench shower waste
• OPTIONAL: sign-mounting hardware
Local codes may require the installation of a backflow
prevention valve to complete proper installation. Compliance
with local codes is the responsibility of the installer. Valve
must be tested annually to verify that it is functioning
properly. Backflow prevention valves are not included with the
fixture and may be supplied by the contractor or purchased
from Bradley Corporation.
IMPORTANT! Do not rely on Bradley's Combination Unit to
support supply piping.
Step 1: Assemble and Install
Drench Shower
1. Install four suitable anchors (supplied by installer) for ⁵⁄₈" bolts in
the floor.
2. Bolt the base to the floor anchors using ⁵⁄₈" bolts (supplied by
installer).
3. Assemble the remaining drench shower components as shown
on page 4.
• Apply PVC compatible pipe sealant or teflon tape (by
installer) to all male-threaded pipe joints.
• The bottom edge of the showerhead should be 84"
(2134mm) from the floor.
4. Connect the water supply piping to the 2" PVC inlet on the unit
(piping by installer). Provide adequate supports (supplied by
installer) for supply pipe using pipe hangers or other means.
5. Connect the drain piping to the 2" PVC drain outlet on the unit
(piping supplied by installer).
Step 2: Assemble and Install
Eye/Face Wash
See pages 4–5 for part identification.
1. While holding the elbow in the lower assembly piping, thread
pipe #113-946 (Item #21) through the hole in the lower assembly
piping, and connect to the elbow.
2. Install the reducer on top of the elbow.
3. Center the elbow, then tighten the pipe #113-946 (Item #21) in
place.
4. Install the union and pipe nipple on pipe #113-946 (Item #21).
5. Place the gasket, then the strainer, on top of the lower assembly
piping.
6. Place the eyewash bowl on top of the strainer.
7. Install the yoke assembly by connecting the stainless steel pipe,
at the base of the yoke assembly, to the reducer on the elbow.
8. Connect the pipe nipple to the valve piping assembly.
Bradley • 215-1134 Rev. V; ECN 12-05-033
26³⁄₈"
(670mm)
4½"
(114mm)
Ø 3¹⁄₁₀"
(79mm)
9"
(229mm)
84"
(2134mm)
to floor
43³⁄₈"
(1100mm)
(4) Ø ¾" (19mm)
Holes on Ø 4¾"
(121mm) Bolt Circle
All dimensions assume standard thread
engagement. Variations in manufacturing
allow for +/- ⁄
1
8
To find the tolerance of a dimension, add
the number of thread joints in between a
dimension and multiply it by
3/14/2013
S19-310PVC
36"
(914mm)
8"
(203mm)
" (3mm) per threaded joint.
⁄ " (3mm).
1
8
66"
(1676mm)
to floor
3