Publicité
Les langues disponibles
Les langues disponibles
NOTES:
• Use the Remote Control, you can set the Alarms in STANDBY mode or operation mode.
(The ALM1/ALM2 on the top panel can only be set when the system is in the standby mode.)
• When setting the alarm be sure to observe to confirm that you have set the wake-up hour
correctly.
• The procedure for setting Alarm 1 and Alarm 2 is the same. The example below is for Alarm 1.
1).
Press and hold the ALM 1 button on remote control or touch
and hold the ALM 1 control on top panel, while the system is
in the standby mode, the default alarm time (6:00) and the
default alarm mode (iPod
Continue holding the ALM 1 button until only the HOUR digits
are flashing.
2).
Press the
or
or
TUNE/SKIP
the display to the desired wake-up Hour.
3).
Press the ALM 1 button again. The Hour digits stop flashing
and the Minute digits begin flashing.
4).
Press the
or
or
TUNE/SKIP
the display to the desired wake up minutes.
5).
Press the ALM 1 button once more to select the wake-up
Alarm Mode (iPod
Mode indicators will be flashing in the display. Press the
buttons on the remote control or touch the TUNE/SKIP
control on the top panel repeatedly to select the desired
wake up mode, iPod
6).
Press the ALM 1 button once more. If you selected either the
iPod
or Radio Alarm Mode, the Volume Level indicator begins
®
flashing. Press the
touch the TUNE/SKIP or
Volume /
up volume level. Note: if you selected the wake up to Buzzer
alarm mode the volume level is fixed and cannot be adjusted.
7).
When all settings are completed press the ALM 1 button once
more to exit the setting mode and activate Alarm 1. The
display will continue to show all of your alarm settings for a few
seconds and then return to the current time. However the
Alarm 1 indicator ( ) will remain in the display to confirm that
the alarm is active.
ALARM SETTING
) begin flashing in the display.
®
buttons on the remote control or touch the
control on the top panel repeatedly to set
buttons on the remote control or touch the
control on the top panel repeatedly to set
, Radio or Buzzer). One of the 3 Alarm
®
, Radio, or Buzzer (BUZZ).
®
or
buttons on the remote control or
control on the top panel – not the
buttons - repeatedly to set the desired wake
47
or
or
Publicité
