Akai AMP-10 Manuel D'utilisation page 39

• Make sure that you have fully extended the FM antenna wire.
• Be sure to connect the external MW Loop Antenna to the MW Antenna Jack on the back
panel if you are planning to listen to MW radio stations (refer to page 43 for connection
information) .
• Make sure you have removed the mylar insulation tab from the remote control.
• Make sure that the system is connected to an AC outlet that is always "live".
• Do not connect the system to an AC outlet controlled by a wall switch.
General Controls
Most of the main functions of this system can be operated by the controls on the top panel
of the main unit, or by the buttons on the remote control. If a specific function can
only be operated by the remote control, or by the top panel controls, this will be clearly
indicated in the instructions.
When operating this system with the remote control, make sure that the IR (Infrared)
transmitter on the front of the remote control is pointed at the remote sensor on the front
panel of the main unit.
The effective operating range of the remote control is approximately 20 feet. Please note that
bright sunlight or room lighting may interfere with the remote control operation. If the remote
control is not operating properly, try reducing the brightness of the room or moving closer to
the main unit. If this does not solve the problem, it may be time to change the remote control
battery.
Auxiliary Input Jack
This system includes an AUX IN Jack to allow you to connect external audio equipment
and listen to the sound from the external equipment through the speakers of this system.
To listen to the external audio source:
• Connect the external audio equipment to AUX IN jack on the rear panel of the system as
shown below. The connection cable is not included:
Select the AUX mode by repeatedly touching the MODE button
on the top panel or by repeatedly pressing the MODE button on
the remote control until the "AUX" indicator appears above the
time display.
OPERATING INSTRUCTIONS
CONNECTING EXTERNAL DEVICES
MW ANT
Signal cord (not included)
plug
38
External audio source