Akai AMP-10 Manuel D'utilisation page 40

Sensor-Touch Control Information
All of the controls on the top panel of the main unit, with the exception of the
and the iPod SELECT control, are special 'Sensor-Touch' controls. There are no buttons to
®
'push'. When you softly touch one of these 'buttons', it will flash 3 times to confirm it
understood the command, and then the system will react accordingly.
Daylight Saving / Standard Time Selection
Note: This adjustment can only be made when the system is in the Standby Mode.
If you are currently observing Daylight Saving Time you should make this adjustment before
you set the actual time. If you are currently observing Standard Time you do not need to make
this adjustment now. Wait until the beginning of Daylight Saving Time.
1. With the system in the Standby mode, touch and hold the
MODE control on the top panel or press and hold the MODE
button on the remote control until the number "1" will briefly
appear above the time display and the DST indicator also
appears. The display will advance by one hour. After a few
seconds the number "1" indicator disappears but the DST
indicator remains in the display to confirm that the clock is
showing Daylight Saving Time.
2. At the end of Daylight Saving Time touch and hold the MODE
control on the top panel or press and hold the MODE button
on the remote control. Until the number "0" will briefly appear
above the time display. The display will back up by one hour.
After a few seconds the number "0" indicator and the DST
disappears to confirm that the clock is showing Standard Time.
SETTING & BASIC OPERATIONS
39
/ ON control