Bosch CR24 Mode D'emploi Et De Montage page 52

52 | en
Starting the CD mode
If there is no CD in the drive
f Insert the CD with the printed side
upwards gently into the CD slot 5 until
you can sense some resistance.
The CD is automatically drawn into the drive.
The display shows the CD symbol.
Note:
You must not hinder or assist the
f
drive as it draws in the CD.
If you insert a CD when the
f
device is switched off, it will be
taken in, but the device will not
start play.
The CD starts playing. The number of the
current track is shown on the display
(e.g. "T12"), along with the time for which the
track will play.
If there is already a CD in the drive
f Press the SRC > button repeatedly until
"CD" appears on the display.
Playback begins from the point at which it was
last interrupted.
Displaying time elapsed or remain-
ing
In order to change between display of the
elapsed or remaining time in the current track,
f Press the 6 < button.
Selecting tracks
f Press the or
the previous or next track.
7 620 210 016 | 11.2013
8 button to change to
If the current track has already been playing for
longer than 10 seconds, pressing the
button once will start it again.
Fast searching (audible)
In order to search rapidly backwards or
forwards
f Hold down the
you reach the desired location.
Random track play (MIX)
f Press the 3 < button. The display briefly
shows "MIX ALL" and the MIX symbol
appears. The next tracks are selected in
random order.
Canceling MIX
f Press the 3 < button again.
The display briefly shows "MIX OFF" and the
MIX symbol disappears. Normal playback is
then resumed.
Scanning tracks (SCAN)
To scan all the tracks of the CD for about
10 seconds each,
f Press the 4 < button.
"SCAN TRK" briefly appears on the display.
Canceling the scan and continuing
listening to a track
To cancel scanning,
f Press the 4 < button again.
"SCAN OFF" briefly appears on the display. The
current track continues playing.
Repeating tracks (RPT)
f Press the 2 < button.
Robert Bosch Car Multimedia GmbH
CD operation
8
or 8 button until