Power Fist 9051475 Mode D'emploi page 6

9051475
CHARGER PRECAUTIONS
WARNING! Voltage is present at the charging terminals, do not probe
with conductive objects. Electric shock or electrocution may result. A
battery short can cause a large current flow, overheating, possible burns
and even a breakdown of the tool.
1. Only use the included battery charger to recharge the battery. Other
chargers may be unsafe, causing an electrical short circuit or fire.
2. Disconnect the charger from its power source before attaching or
removing batteries or battery clamps.
3. Charge the battery in a well-ventilated area and never obstruct the vents
in the top and bottom of the charger. Place the charger on a flat non-
flammable surface and away from flammable materials when re-charging
the battery.
4. Do not place any object on top of the charger or place the charger on a
soft surface that may result in excessive internal heat. Place the charger
in a position away from any heat source.
5. Charge the battery at rates recommended by the battery manufacturer.
6. Make sure the polarity symbols on the battery lines up with the polarity
symbols of the charger. A battery inserted backwards may explode
causing fire and/or injury.
7. Do not use the charger with an extension cord. This can cause a low
voltage outage during charging.
8. Do not charge leaking batteries. A compromised casing will release
volatile chemicals and gases. Charging a leaking battery can cause a fire
or explosion.
9. Do not operate the charger if it has received a sharp blow, been dropped
or otherwise damaged in any way. Have it serviced or replaced.
ELECTRICAL SAFETY
WARNING! Do not touch or handle a live tool with any part of your body
that is wet or damp. Wet skin reduces resistance to electrical current,
increasing the danger of a serious or fatal shock.
WARNING! To reduce risk of electric shock, be certain that the plug is
connected to a properly grounded receptacle.
www.princessauto.com / 1-800-665-8685
20V 4A LI-ION FAST BATTERY CHARGER V1.1
Page 6