Hella Gutmann SEG V Mode D'emploi page 111

Hella Gutmann
7.9.6.1. Installing the Network Manager
The use of the function Asanetwork requires the network manager "netman" installed on the shop PC. This software is a
product of a third-party supplier and can be acquired under the following link:
https://workshop-net.net/netman/
The use of the software requires merely 5 steps:
1. Download and install the network manager.
2. Start the network manager and go to Documented text > Start asanetwork and connect with the SEG V.
The connected SEG V is indicated under Connected services.
3. The purchase of the device license requires a registration. For this select the tab >License< in the drop-down menu
and confirm the selection Click here for free registration under Free registration required.
This option is indicated only if step 2 was successful.
4. Enter the license, that has been transmitted by e-mail, under License activation for the online activation and click to
>Save<.
ð The license is activated now.
7.9.6.2. Processing an Asanetwork Order in the SEG V
If an order is created in the commercial software, call up the configured order in the headlight aiming device as follows:
1. Select Documented test > Vehicle selection > Start asanetwork in the main menu.
The info window shows that the dial-up to the asanetwork controller is being established.
A list of the created asanetwork orders appears.
2. Selected the relevant order.
This entry is marked in green now.
3. Confirm the selection with
The Target specifications window appears.
4. Abort the procedure with
5. If required, change the data as described in the section Entering Vehicle Data [} 99].
The headlight setting data shall correspond to the manufacturer's specifications.
6. Open the Headlight selection window with
7. Perform the headlight test as described in the section Performing headlight test [} 130].
8. Finish the measurements with
An info window indicates that the results are being sent to the asanetwork DMS.
9. Confirm the selection with
The window closes and the main menu appears again.
10. Abort the procedure with
ð In the DMS software the order is indicated as done now. The results are listed in the corresponding protocol.
SEG V
.
.
.
.
.
.
Device configuration | 7.
111