Installation - Burg BKG178A++ MF Guide D'utilisation

INSTALLATION

Installation instructions and door reversibility
Before installation, read the instructions carefully.
Fit the refrigerator/freezer in stable kitchen units only.
If necessary, reverse the door according to instructions.
Check the installation dimensions according to fig.C. The position of the joint between the
unit doors must be level with the position of the joint between the appliance doors.
1. See fig.A for the necessary attachment components.
2. Unscrew two screws at the top surface. (fig.D)
3. Peel the double sided tape at the bottom surface of trim flap
and screw by 2 screws(6) to left / right side. (fig.E)
IMPORTANT NOTICE: Do not screw any screw to the middle.
4. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
5. Take out the trim gasket
reverse side of the door hinges of the appliance. (fig.E - fig.F)
6. Raise appliance and slide into the kitchen unit. Push the appliance to the reverse side
of door hinges providing that the trim gasket
kitchen unit.
7. Align front feet with the front surface of the kitchen unit. (fig.G)
8. Screw the front feet by using screws
9. Screw the trim flap
10. Screw the fixing bracket
the opposite side. (fig.I)
11. Screw guides
3
unit door as it is opened at right angle. Slide rails
Screw the rails
4
12. Set 1~2 mm gap on the handle side between the unit itself and the unit doors by
adjusting the guides
located on the side panel of the appliance and stick it on the
2
to the kitchen unit using screws
1
, as leaned to kitchen unit by using screws
11
to the appliance doors with screws
to the unit doors with screws
. This is vital for appliance performance. (fig.J)
3
covers space between appliance and the
2
. (fig.G)
5
. (fig.H)
5
. Lean the appliance doors to the
6
into the guides
4
. (fig.J)
5
EN - 45 -
. Insert trim flap
(1) (1)
. Repeat this for
5
aligning the groove.
3
into slot