Publicité
Fl LTE R REMOVAL & REP LAC EM E NT
unplug cleaner before changing filter.
This upright contains two filters: HEPAfilter (side of cleaner) and PERMA FILTER" with CleanStreamm Filtration (in dirt container) which combined pre-
vent dust and allergens from escaping the vacuum and re-entering the air.
HEPA FILTER
(external)
-
Part# 3-690320-001 located on side of cleaner.
The HEPA Filter should be replaced annually. Write date of filter replacement on label.
1. Grasp tab located at the top of the HEPA filter cover and pull away from the cleaner (Diagram 1).
2. Grasp HEPA filter Cartridge and pull out (Diagram 2). IMPORTANT: Do NOT clean with water.
3. For HEPA filter replacements call 1-800-321-1134 (USA & Canada).
4. To Replace: Lay HEPA filter in cover with gasket facing up. Close the cover by pushing it firmly until it snaps into place (Diagram 3).
NOTE: If filter cover is knocked off, replace by aligining the bottom tabs and snapping into place.
PERMA FILTERmWITH CLEANSTREAMmFILTRATION
(internal)
-
located in dirt container.The filter should
not need to be replaced but should be cleaned every time the dirt container is emptied to maximize perfor-
mance of the vacuum (see page 6: Cleaning the PERMA FILTER" with Cleanstream" Filtration).
LIGHTBULB REMOVAL AND REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK
-
UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321 -11 34 or your local auto parts store.
1. Lean cleaner handle back. Insert end of standard (flat head) screwdriver into side slot and pry outward to pop headlight lens out
(Diagram 1).
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place.
Publicité
