decorflame QCM375ST-38B Mode D'emploi page 7

All manuals and user guides at all-guides.com
A S S E M B LY I N S T R U C T I O N S
Step 3: Attach the POWER SUPPLY on the
TOP PANEL [A] and secure the cord in place
with MOUNTING CLIPS [X]. Connect he CON-
NECTORS of lamps [# 2] to the power cord [#
3]. See Fig. 3a and Fig. 3b
MANTLE ASSEMBLY:
CAUTION: Place a piece of cardboard or
protective sheet on the floor in order to avoid
scratching the decorative surface of your
mantle during assembly.
Please DO NOT fully tighten the KD screws
until all panels are assembled.
Step 1: Attach the CONNECTORS [I] to the
UPPER FRONT [C] with 4 Medium KD SCREWS
[M] as shown in Fig. 4
Fig. 2
Step 2: Attach all PLASTIC CONNECTORS [N]
to the parts [C, D, G and H] as shown in Fig.
5 (2 screws for each PLASTIC CONNECTOR)
Fig. 3a
Fig. 3b NOTE: If the KD SCREWS do not fit during
assembly, loosen the 2 screws to adjust the
PLASTIC CONNECTOR until the parts/KD
SCREWS can be installed.
Step 3: Attach the BACK PANELS [D] to LEFT
SIDE [G] and RIGHT SIDE [H] with 6 MEDIUM
KD SCREWS [M] as shown in Fig. 6
7
Fig. 4
Fig. 5