Publicité
Les langues disponibles
Les langues disponibles
CAUTION: The Electric Fireplace Heater
should not be positioned in area exposed to
direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substi-
tute for proper adult supervision. Children
should not be left unattended near
any heater.
1. Drill a 5/16" (8mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantle close
to the wall.
3. Attach the SAFETY CABLE to the mantle
using the SCREW FOR MANTLE. See
figure 14.
All manuals and user guides at all-guides.com
O P E R A T I O N
4. Use the SCREW FOR WALL to attach the
other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
After reading complete instructions, confirm
all controls on fireplace are in the OFF posi-
tion. Plug the fireplace into a 15AMP/120Volt
outlet. If the cord does not reach, you may
use an extension cord rated for a minimum
of 1875 WATTS. Once the fireplace insert
has been properly connected to a grounded
electrical outlet, it is ready to operate.
OPERATION for
HALOGEN LIGHTS
1. Plug lamp into power supply.
2. Turn switch to ON position.
BULB REPLACEMENT for
HALOGEN LIGHTS
WARNING: Switch off and unplug the unit
and allow it to cool before replacing bulb(s). 1.
Loosen the LOCKING SCREW [U] to remove
the LAMP COVER [Q].
2. Never touch the bulb with bare hand. Use
a soft cloth to change the bulb, JC type Max
10W watt 12V halogen bulb(s). Fig. 15
Fig. 14
10
Fig. 15
Publicité
