Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE WARNING:
Disconnect power and unplug the power
cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid
the accidental burning of the skin.
RISK OF FIRE:
Do not exceed the
recommended bulb
wattage.
REPLACING THE
LIGHT BULBS
Step 1:
Remove 4 screws on the back
of fireplace and remove the rear
cover of the unit.
Step 2:
You will find 1 X 60W Type B-10
bulb under log-set bed.
Step 3:
Loosen and remove burnt out bulb
and replace with new bulb.
Step 4:
Close the rear cover and secure
with the 4 screws.
Step 5:
Plug in the unit.
All manuals and user guides at all-guides.com
M A I N T E N A N C E
SELF REPAIR SET
Touch-up repair paint
1. Paint directly on the mantel unit if
necessary. Fig. A
If any problems are found with the original
parts during mantel assembly such as the
panels cannot be installed with the plastic
connector. Try to solve by one of the follow-
ing method.
Tools required: Electric drill, drill bits 3/4
inches (10 mm) or 1/16 inches (2 mm), Pen-
cil, Hammer, Philips Screwdrivers, Safety
Goggles and gloves (if necessary).
WARNING: Wear goggles when using power
tools.
Option 1: Use the spare KD NUTS, KD-
SCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the
12
Fig. A
Publicité
