Cleaning Instructions - Bosch BGS 4 Serie Mode D'emploi

Cleaning a washable (H)EPA filter
The (H)EPA filter with the "washable" imprint is desig-
ned so that it does not need to be replaced, provided
the appliance is used as intended in the household.
To ensure that the vacuum cleaner is working at its op-
timum power level, the exhaust filter should be rinsed
out after one year. The filtering action of the filter re-
mains intact, even if the filter surface becomes disco-
loured.
27*
Fig.
a) Open the lid of the exhaust filter by pushing and
pulling on the locking tab.
b) Unlock the (H)EPA filter and remove it from the ap-
pliance.
c) Tap out the filter unit and rinse it under running wa-
ter.
Alternatively, the unit can be cleaned in a washing
machine at max. 30 °C using a gentle programme
and the lowest spin speed.
TIP: To protect other laundry items, put the filter
unit into a laundry bag.
d) Once the (H)EPA filter has dried completely (at least
24 hours), insert it back into the appliance and lock
it in place.
= Close the exhaust filter lid. In doing so, push the >
lock bar upwards until it audibly clicks into place.
Replacing the (H)EPA filter
(only for appliances without a washable (H)EPA filter)
To ensure that the vacuum cleaner can work at its opti-
mum power level, the (H)EPA filter should be replaced
after one year.
28*
Fig.
a) Open the lid of the exhaust filter by pushing and
pulling on the locking tab.
b) Unlock the (H)EPA filter and remove it from the ap-
pliance.
c) Dispose of the old (H)EPA filter with your household
waste.
d) Insert the new (H)EPA filter into the appliance and
lock it in place.
= Close the exhaust filter lid. In doing so, push the >
lock bar upwards until it audibly clicks into place.
Micro filter
Cleaning the micro filter
The micro filter is designed so that it does not need to
be replaced, provided the appliance is used as inten-
ded in the household.
To ensure that the vacuum cleaner is working at its op-
timum power level, the exhaust filter should be rinsed
out after one year. The filtering action of the filter re-
mains intact, even if the filter surface becomes disco-
loured.
29*
Fig.
a) Open the lid of the exhaust filter by pushing and
pulling on the locking tab.
b) Pull the locking tab to unlock the filter unit with foam
filter and microfilter and remove it from the appli-
ance.
c) Remove the foam filter and microfilter from the filter
frame.
42
d) Rinse the foam filter and micro filter under run-
ning water. Alternatively, they can be cleaned
in the washing machine at max. 30 °C using a
gentle programme and the lowest spin speed.
TIP: To protect other laundry items, put the unit into
a laundry bag.
e) Once the foam filter and microfilter have dried com-
pletely (at least 24 hours), insert them back into the
filter frame.
f) Insert the filter unit in the appliance and ensure that
the locking tabs audibly click into place.
g) Close the exhaust filter lid. In doing so, push the lock
bar upwards until it audibly clicks into place.

Cleaning instructions

Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Caution:
Do not use abrasive materials, glass-cleaning
agents or all-purpose cleaning products. Never im-
merse the vacuum cleaner in water.
Subject to technical modifications.
* Dependent on model