Cleaning Instructions - Bosch easyy'y BGS 2 Série Mode D'emploi

Maintaining the dust-collection system
Your appliance is equipped with a Sensor Control indi-
cator. This function constantly monitors whether your
vacuum cleaner is working at its optimum power level.
20
Fig.
20
Fig.
The indicator (blue ring) flashes red when the filter in
the dust container needs to be cleaned. The appliance
is automatically adjusted to the lowest power level.
Cleaning the filter in the dust container
Switch off the appliance.
21
Fig.
a) Open the bottom plate of the dust container by
pulling on the lower catch.
b) Fold out the filter cartridge with foam filter and
fleece filter.
c) Remove the foam filter and the fleece filter from the
bottom plate of the dust container.
d) Tapping out both parts is all that is required to be
able to stop the suction process.
e) Then clean the foam filter and the fleece filter under
running water.
Alternatively, the two filters can be cleaned in the
washing machine at max. 30 °C using a gentle pro-
gramme and the lowest spin speed.
TIP: To protect the filters, place them in a laundry
bag.
f) Allow the foam filter and the fleece filter to dry com-
pletely for at least 24 hours and then place both fil-
ters back in the bottom plate of the dust container.
g) Close and lock the bottom plate.
Maintaining the exhaust filter
The exhaust filter is designed so that it does not need
to be replaced, provided the appliance is used as inten-
ded in the household.
To ensure that the vacuum cleaner is working at its op-
timum power level, the exhaust filter should be rinsed
out after one year. The filtering action of the filter re-
mains intact, even if the filter surface becomes disco-
loured.
22*
Fig.
a) Open the top cover by pressing on both sides of the
catch and remove it upwards.
b) Unlock the exhaust filter and remove it from the ap-
pliance.
c) Tap out the exhaust filter and rinse it under running
water.
Alternatively, the unit can be cleaned in a washing
machine at max. 30 °C using a gentle programme
and the lowest spin speed.
TIP: To protect the other items in the machine,
place the filter unit in a laundry bag.
d) Once the exhaust filter has dried completely (for at
least 24 hours), put it back into the appliance and
lock it in place.
= Put the top cover back on the appliance so that it =>
'clicks' audibly into place.

Cleaning instructions

Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Caution:
Do not use abrasive materials, glass-cleaning
agents or all-purpose cleaning products. Never im-
merse the vacuum cleaner in water.
Subject to technical modifications.
* Dependent on model
39