EINHELL DTA 25/1 Instructions D'utilisation Et D'entretien page 5

Anleitung DTA 25-1 28.11.2005
Dear Customer,
Before you use the stapler for the first time, please
read these instructions and note the information for
the tool's operation and maintenance.
Always keep this manual with the tool.
1. Technical data
Permissible working pressure max.
Air consumption approx. ca. 011 L/min.
Staple width
Staple length
Nail length
Recommended hose diameter
Air quality cleaned and oiled
Compressor capacity
approx. 250 l/min. equivalent to a motor
rating of 2.2 kW
Work settings
6 bar working pressure set at the pressure reducer
or filter pressure reducer
Sound pressure level LPA 80,8 dB(A)
Sound power level LWA 91,8 dB(A)
Vibration a w
Please note:
When working with the stapler, be sure to wear
the necessary protective clothing, particularly
goggles.
Observe the safety regulations.
2. Illustration
Item. Description
A trigger lever
B magazine
C magazine lever
D plug-in nipple for the air supply
E air connection
F Swivel air-outlet
10:21 Uhr Seite 5
F
A
6 bar
B
5 mm
13-40 mm
3. Proper use
16-50 mm
9 mm i Ø
The stapler is a pneumatic tool for universal service.
The exhaust air leaves the housing to the front.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.
4. Safety regulations
2,5 m/s 2
Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the stapler to any use other than that
intended.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work if
you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Wear the necessary protective clothing,
particularly goggles and safety gloves, when
working with the stapler.
Do not exceed a maximum pressure of 6 bar.
Never point the stapler at any persons when it is
connected up and loaded.
GB
E
D
C
5