Flex FX1331 Manuel De L'utilisateur page 15

NOTICE:
a. Always use the correct type and size of bit for
your application.
b. When turning in a screw at/near the crosscut
end or an edge of wood, pre-drill a hole in
order to avoid cracking of the wood.
c. When screw driving in hard wood, one should
pre-drill a pilot hole.
WARNING
can break the fastener. Keep the impact
driver at a right angle to the fastener to
avoid damaging the fastener head.
Do not over-tighten, as the
force of the impact driver
Fig. 11
-15-