SEVERIN MW 7885 Mode D'emploi page 13

∙ Should any smoke be noticed during operation, keep the door closed to inhibit or
smother any flames. Switch the unit off immediately and remove the plug from the
wall socket.
∙ To prevent danger of burns, a suitable oven-cloth must always be used when
removing food from the oven, since the utensils and cooking containers heat up
with the food.
∙ Food thermometers must not be used.
Before first use
∙ After unpacking and every time before connecting the unit to the power supply,
check the unit and its power cord carefully for any signs of damage.
∙ Warning! Ensure that the door, including the viewing window and door locks, are
not damaged or bent and that it closes firmly against the support. This is important
to ensure that no microwave energy is allowed to escape during operation. For the
same reason, the entire casing as well as the inside of the oven must be carefully
checked.
In the event of damage, do not operate the appliance until it has been repaired by a
person trained to do so.
∙ Remove any exterior and interior packaging materials. All these materials are suitable for recycling. Remove the adhesive
strip over the drive.
∙ Do NOT remove the protective film stuck to the inside of the door or the grey-brown protective cover (5) next to the
interior light on the right-hand side of the cooking area.
∙ Caution: Keep any packaging materials well away from children – such materials are a potential source of danger, e.g. of
suffocation.
∙ Before the appliance is used for the first time, or after extended periods of non-use, it should be thoroughly cleaned as
described in the section Cleaning.
∙ Insert the roller ring/drive unit and the glass turntable into the unit.
∙ Do not operate the appliance without the roller ring/drive unit and glass turntable properly fitted.
Note: Do not switch the unit on unless the food to be heated or cooked has been placed inside the oven. Operating
the appliance empty could result in damage to the unit.
ISM Device
This appliance is a group 2 class B ISM device. Group 2 contains all ISM devices (industrial, scientific, medical) generating
radio frequency energy and/or using radio frequency energy in the form of electro-magnetic radiation to process materials;
it also comprises spark erosion devices. Class B specifies devices designed for domestic use, or any similar devices
integrated in the general power grid supplying domestic units.
The microwave function (Group II in compliance with EN 55011)
Electromagnetic energy is generated inside the unit, causing the molecules in the food (mainly water molecules) to oscillate and
subsequently causing the food to become hot. Food with high water content will therefore heat up faster than relatively dry food.
The heat is generated gradually inside the food. Any utensils, container or plates used are heated up only indirectly as a result
of the food temperature.
13