Publicité
Les langues disponibles
Les langues disponibles
Connections
*
Turntable
Mains plug may vary to some extent depending on sales area, local laws and regulations.
Tuner
Speaker systems
OUTPUT
-{ Tp
Compact disc player
aw,
ar Ma oe
Before connecting the power plug
Before connecting the power plug to an electrical outlet, check to be
sure that the unit is set to the proper voltage for your area.
If the
voltage of the unit is improperly set, fire hazard or damage to the unit
may result.
If you find that the unit is not set to the proper voltage
for your area, follow the instructions listed below:
©
Units with
120V/220V/240V VOLTAGE SELECTOR at rear
panel
These units are set at either 120V, 220V or 240V with the VOL-
TAGE SELECTOR.
To change the voltage use a minus screwdriver
to remove the plug, and reinsert it so that the mark ( 4) matches
the desired voltage.
VOLTAGE SELECTOR
)
VOLTAGE SELECTOR
'TE
jb
Isa
-@
Im"
ile
@
® @
LINE IN-LINE OUT
(REC)
(PLAY)
* For the United
Kingdom only
PRS A
A
2S
A
RT A
I
[|=
rT
Tape deck
AR
MET DIO NIE A
a
¢
Units with 220V/240V VOLTAGE
SELECTOR
switch at
rear panel
These units are set at either 220V or 240V with the VOLTAGE
SELECTOR switch.
To change the voltage, use a minus screw-
driver or similar device to slide the switch.
VOLTAGE SELECTOR
VOLTAGE SELECTOR
220V +» 240V
220V
——> 240V
~ 50/60 Hz
~ 50/60 Hz
At 220V
At 240V
¢
Units without voltage selector switch
Units destined for some areas are not fitted with a voltage selec-
tor switch due to laws and regulations existing in those areas.
In such a case, the power supply voltage is set to the voltage used
in the area where the unit is purchased.
If the unit is to be used in an area where the power requirements
are different, make sure you consult your nearest authorized
SANSUI Service Station.
Publicité
