GE 24 Mode D'emploi page 12

Drawer Removal
Drawers will stop before coming all the way out of refrigerator to help
prevent contents from spilling onto floor. Drawers can easily be
removed by tilting up slightly and pulling past "stop" location.
On some models you may need to remove the door bins from the fresh
food door before removing the drawers.
If the door prevents you from taking out the drawers, the refrigerator
will need to be rolled forward until the door opens enough to slide the
drawers out. In some cases when you roll the refrigerator out you will
need to move the refrigerator to the left as you roll it out.
Light Bulb Replacement
Fresh Food Compartment–Upper Light
1. Unplug refrigerator.
2. To align the control knob
properly, note position of
numbered control for proper
reassembly, turn control to
OFF and pull off knob.
3. Pull bottom of light panel
down about 1/4 inch (6 mm)
just enough to disengage lip at
rear from grooves in retainers
on rear wall.
4. Lift panel to disengage top from pins on side walls and
remove panel.
After replacing with same size bulb, reinstall panel (hang top on pins;
pull bottom down, push it back and release it to let lip engage grooves
in retainers). Replace temperature control knob in OFF position, turn
it to previous setting and plug refrigerator back in.
12
CARE AND CLEANING
Pin
Grooved
retainer,
one on
each side
(continued)
Drawer guides
Left side
When replacing the drawers, make sure you slide them through the
drawer guides on the left side.
Freezer Compartment
1. Unplug the refrigerator.
2. Remove the shelf just below light shield. (The shelf will be easier
to remove if it is emptied first.)
3. Pull the light shield toward you to reach the bulb.
After replacing with same size bulb, reinstall shelf and plug the
refrigerator back in.