Publicité
Les langues disponibles
Les langues disponibles
Installation
■ Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the
two locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
■ Removing the Unit
1
2
3
Catch
Lock
4
— 28 —
— 28 —
Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
Remove the screw (M4 × 8) on the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown.
Screw (M4X8)
(commercially
available)
Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory2
Removal tool
Publicité
