Bosch BGC05 Serie Mode D'emploi page 31

17
Fig.
To pack the appliance away, pull the handle out of the
telescopic tube (
3
Fig.
Slot the adapter into the stand on the rear of the
‡
appliance.
Coil the suction hose around the appliance and
‡
secure it in the bottom clamp in the hose clip.
Coil the suction hose around the appliance a
‡
second time and secure the handle in the top clamp
in the hose clip.
Finally, release the suction adapter, pull it out of
‡
the appliance and clip it onto the handle
( ).
2
Fig.
Cleaning and care
Emptying the dust container
18
Fig.
In order to achieve the best possible vacuuming re-
sults, the dust container should be emptied after every
use or, at the latest, when dust at one point in the con-
tainer has reached the mark.
19
Fig.
Press the release button to release the dust contai-
‡
ner, and take hold of the handle to remove it from
the appliance.
Hold the dust container over the dustbin and press
‡
the release button to release the bottom cover. The
dirt and dust will then fall straight into the bin.
Close and lock the bottom cover.
‡
‡ Insert the dust container into the appliance and
lock it in place.
Maintaining the dust-separation system
To keep them in good working order, the filters should be
cleaned at least every 3 months.
Cleaning the filter in the dust container
Switch off the appliance.
‡
20
Fig.
‡ Open the lid on the dust container by pulling on the
lower catch.
Remove the frame with the filter from the lid.
‡
Remove the filter foam from the filter frame.
‡
If necessary, remove any hair and dust, and tap the
‡
motor protection filter and filter foam.
Both filters and the dust container can be washed
‡
under running water.
After cleaning and thoroughly drying them, reas-
‡
semble all the parts and place them back in the
appliance.
!
Caution
Do not place the parts back in the appliance before
they are completely dry.
!
Never use the vacuum cleaner without the filter.
=> This may damage the appliance.
).
Exhaust filter care
21
Fig.
Press the catch on the left-hand side to open the
‡
exhaust grille.
Press the catch at the top of the exhaust filter to
‡
release the filter, and take it out of the appliance.
‡ Tap the exhaust filter and wash it under running
water.
Once it is completely dry, place the exhaust filter
‡
back in the appliance and close the exhaust grille.
Cleaning instructions
Always switch off the vacuum cleaner and unplug the
mains plug before cleaning the vacuum cleaner. The va-
cuum cleaner and plastic accessories can be cleaned
with standard plastic cleaner.
!
Caution:
Do not use abrasive cleaning products, glass clea-
ner or multi-purpose cleaning products. Never im-
merse the vacuum cleaner in water.
Subject to technical modifications.
* Depending on model
31