Alice's Garden FINLAND Mode D'emploi page 37

ADVICE IN CASE OF FAILURE
PROBLEM REASON
The safety/reset button on the pressure
regulator has not been pushed.
The valve of the gas set point is
closed / Gas bottle is empty
Pilot orifice or tube is blocked
The pilot light does
not turn on
There is air in the gas line
Gas pressure is low
The piezo igniter does not work
Accumulation of dirt around the pilot
light
The pilot light The connection between the gas
does not stay lit
valve and the pilot is loose
The thermocouple is not working
correctly.
Gas pressure is low
The burner does
The orifice is blocked
not light
The switch is not on
the «HIGH» or «LOW» position
Gas pressure is low
Outside temperature
The flame of
is greater than 5˚C and the cylinder
burner is weak
is ¼ full
The supply hose is folded or
Note : do not
twisted
turn on
the device when
the temperature is
The switch is not on
lower than 5˚C
the «HIGH» or «LOW» position
Gas pressure is low
The flame of
burner is not
Uniform.
The base is not on a flat surface
Note : the bottom
2.5 cm part of the
burner should not
have a flame.
Accumulation of dirt on the burner
Carbon accumu- Dirt or cover on the reflector
lation and the transmitter
Thick black smoke The burner is clogged
13/07/2022
SOLUTION
Press the reset button on the regulator to
start the gas supply
Open valve / Replace set point
Clean the pilot orifice or tube with a brush or
using a brush or a paintbrush
Open and purge the gas line (keep the switch
pressed on PILOT) for 1 within 2 minutes or
until you detect a slight smell of gas
Replace the setpoint
Use a match to light the
pilot light (next page). If it lights up, get a
new igniter and replace it.
Clean the dirt around the pilot light
Tightened the connection and check for
leaks
Replace the thermocouple
Replace the gas cylinder
Clean the orifice
Turn the button to the «ON» position
Replace the gas cylinder
Replace the gas cylinder
Untwist the hose and check there are no
leaks
Turn the knob to the off position
(«OFF»), let the appliance cool down and
make sure that the burner and the orifices
are not blocked
Replace the gas cylinder
Place the heater on a levelled surface
Clean the burner.
Clean the reflector and the transmitter
Turn the knob to the off position
(«OFF»), let the appliance cool down,
remove the cover and clean the inside and
outside burner
EN
37