Télécharger Imprimer la page

DeWalt DXCM602 Guide D'utilisation page 25

Publicité

Les langues disponibles

Les langues disponibles

FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-888-895-4549 for a free
replacement.
HOT SURFACE. RISK OF
BURNS. DO NOT TOUCH.
SUPERFICIE CALIENTE.
RIESGO DE QUEMADURAS.
NO TOCAR.
SUURFACE TRÈS CHAUDE.
RISQUES DE BRÛLURES.
NE PAS TOUCHER.
RISK OF BURSTING
RISQUE D'ÉCLATEMENT
PREVENT TANK CORROSION. AFTER EACH
PRÉVENIR LA CORROSION EN DRAINANT TOUTE HUMIDITÉ
USAGE, DRAIN ALL MOISTURE FROM TANK.
DU RÉSERVOIR APRÈS CHAQUE USAGE.
DRAIN VALVE LOCATED ON BOTTOM OF TANK.
DRENAR LA VÁLVULA UBICADA DEBAJO DEL TANQUE .
N008806
ATENCION
RIESGO DE EXPLOSIÓN
PREVENIR LA CORROSIÓN DEL TANQUE. DESPUÉS DE CADA USO
DRENAR TODA HUMEDAD DEL TANQUE.
SOUPAPE DE VIDANGE SITUÉE SUR LE DESSOUS DU RÉSERVOI.
E106191
GLOSSARY
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air
delivery.
PSI: Pounds per square inch; a unit of measure of pressure.
Cut-in pressure: Factory set low pressure point that starts the
compressor to repressurize the tank to a higher pressure.
Cut-out pressure: Factory set high pressure point that stops
the compressor from increasing the pressure in the tank above a
certain level.
Well-ventilated: A means of providing fresh air in exchange for
dangerous exhaust or vapors.
Dedicated circuit: An electrical circuit reserved for the exclusive
use of the air compressor.
ASME: American Society of Mechanical Engineers. Indicates that
the components are manufactured, tested and inspected to the
specifications set by ASME.
CSA: Canadian Standards Association
Indicates that the products that have this marking have
been manufactured, tested and inspected to standards
that are set by CSA.
Canadian Standards Association (USA): Indicates that the
products that have this marking have been manufactured,
tested and inspected to standards that are set by CSA.
These products also conform to U.L. standard 1450.
California Code: Unit may comply with California Code 462 (l) (2)/
(M) (2). Specification/model label is on the side of the air tank on
units that comply with California Code.
25

Publicité

loading