Mi-T-M Outdoor MH-0018-0D10 Manuel De L'opérateur page 13

IMPORTANT! Always use a propane (LP) cylinder that has a connection device that is compatible with the
hose and regulator assembly supplied.
1. Remove the Back Cover by sliding the cover straight up and away from the Heater Body. Place the LP
cylinder on the Bottom Plate and replace the Back Cover.
2. To connect LP cylinder, insert regulator end fitting into cylinder valve, rotate coupling nut clockwise and
tighten firmly.
3. Open valve on propane cylinder slowly. If the valve is not opened slowly, the excess flow check valve in
the regulator will stop the flow of gas. If this should happen, close the valve, wait one minute (or until you
hear the valve click), and re-open, slowly.
4. Be sure to inspect all connections for leaks, by using a 50/50 mixture of dish soap and water on all
connections. Any bubbles forming indicate a leak.
Propane Heater Manual
ASSEMBLY
13