Technibel Climatisation DSAV92C5TA Notice D'utilisation page 5

TEMPERATURE SENSOR SELECTOR (SENSOR)
G Under normal conditions the room temperature is detected and
checked by the temperature sensor placed in the remote control
unit.
G This button activates the temperature sensor placed in the
indoor unit. Press this button
using a thin object, e.g. the point
of a pencil or a pen. The display
will show the mark. The
air conditioner will be set
according to the intake air
temperature of the unit (mean
temperature of room air).
NOTE
For normal use it is recommended the temperature sensor in
the remote control unit to be activated.
The remote control unit sends the
temperature signal to the air
conditioner regularly at three
minute intervals. If the signal from
the remote control unit stops for
more than ten minutes due to
some troubles, the air conditioner
will switch to the temperature
sensor which is built into the indoor unit and controls the
room temperature. In these cases, the temperature around the
remote control unit may differ from the temperature detected
in the air conditioner position.
REMOTE CONTROL UNIT LOCATION
The remote control unit may operate either from a non-fixed
position or from a wall-mounted position. To ensure that the air
conditioner operates correctly, DO NOT install the remote control
unit in the following places:
G
In direct sunlight.
G
Behind a curtain or other places where it is covered.
G More than 8 m. away from the air conditioner.
G In the path of the air conditioner airstream.
G Where it may become extremely hot or cold.
G Where it may be subject to electrical or magnetic noise.
G
Where there is an obstacle between the remote control unit
and the air conditioner (a check signal is sent from remote
control unit every 3 minutes).
1. Wall-mounted non-fixed
position
• Momentarily place the remote
control unit in the desired
mounting position.
• Verify that the remote control
unit can operate from this
position.
• Fix the support at the wall with
two screws and hang the
remote control unit.
REMOTE CONTROL UNIT
DISPLAY
5
2. Wall-mounted fixed position
• Momentarily place the remote control unit in the desired
mounting position.
• Verify that the remote control unit can operate from this
position.
• Fix the support at the wall with one screw.
• Remove the batteries from the remote control unit.
• Locate the pretrimmed hole in the battery compartment.
• Through the pretrimmed hole fix the remote control unit at
the wall using the supplied screw.
• Insert the two batteries, check that the remote control unit
operates correctly.
(1)
SUPPORT
OPERATION WITH THE REMOTE CONTROL UNIT
CAUTION
Check that circuit breaker on the power panel is turned ON and
the operation selector is in the ON position.
HOW TO USE THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit transmitter
head directly at the air conditioner receiver.
REMOTE
CONTROL UNIT
REMOTE CONTROL UNIT
(2)
TRANSMITTER
HEAD
RECEIVER
EG