Facom CL3.C18S Notice Originale page 24

Model Square drive
in
CL3.C18S 1/2
Model Free speed
tr/min
CL3.C18S 1800
* k = measurement uncertainty in dB ** k = measurement uncertainty in m/s
CAUTION: Ensure fastener and/or system will withstand the level of torque generated by the tool. Excessive torque may cause
breakage and possible personal injury.
1. Place the socket on the fastener head. Keep the tool pointed straight at the fastener.
2. Press switch to start operation. Always check torque with a torque wrench, as the fastening torque is affected by many factors
including the following:
• Voltage: Low voltage, due to a nearly discharged battery, will reduce fastening torque.
• Socket size: Failure to use the correct socket size will cause a reduction in fastening torque.
• Bolt Size: Larger bolt diameters generally require higher fastening torque. Fastening torque will also vary according to
length, grade, and torque coefficient.
• Bolt: Ensure that all threads are free of rust and other debris to allow proper fastening torque.
• Material: The type of material and surface finish of the material will affect fastening torque.
• Fastening Time: Longer fasten ing time results in increased fastening torque. Using a longer fastening time than
recom mended could cause the fasteners to be overstressed, stripped or damaged.
Maintenance
Your FACOM power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious personal injury, place the forward/reverse button in the lock-off position or turn tool off and
disconnect battery pack before making any adjustments or removing/installing attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken
the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Charger cleaning instructions
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Accessories
WARNING: Since accessories, other than those offered by FACOM, have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only FACOM-recommended accessories should be used with this product.
NU-CL3.C18S_0216.indd 24
SPECIFICATIONS
Impact rate Breakaway
torque
Pressure dB(A)
N.m
2400 983 92
Weight Dimensions
kg mm
2.4 241 X 79 X 210
Noise level
Power dB(A)
k* k*
3 103 3
24
Vibrations level
m/s
2
Pressure dB(C)
k* k**
115 3 11.5 2.3
2/26/2016 9:06:08 AM