Publicité
Les langues disponibles
Les langues disponibles
Measure
height of cabinet opening from
underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to "Dishwasher Height Adjustment Chart"
for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet
Wheel
Number-of turns
opening height
position
on-front leg
3374".(86.0 cm)
Removed
All the way-up
34"(86.4.cm)
1
10
34%" (87.0 cm)
2
5
3412" (87.6. cm)
3
0
J
NOTE:
If the minimum
cabinet opening
height is less than
34" (86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 337%" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move.
(Measurements
are approximate. Wheels and legs are preset at the
factory for 3414" [87.6 cm].)
2 | Adjust wheels and legs
2
AL
NN
fi
AVR
—
(2)
EQS
We
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart."
Built-up Floors—Add
shims as needed
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed
in the area shown to bring the dishwasher up to
34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
14
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand the dishwasher up.
Option 1, Countertop attachment:
Tabs must 'point
tothe right
Remove the brackets from the package and place in the
open slots on the left and right-hand top of the
dishwasher collar as shown.
Insert the bracket into the slot on the collar. Using a pair
of pliers, bend the tab down to secure the bracket in
place. Repeat this step for the other side.
NOTE:
Do not attach the dishwasher. This will be done
later.
Option 2, Dishwasher side attachment:
NOTE:
Remove the brackets from the parts package.
1 | Break end of bracket
score line
Break off the end of the bracket along the scored line.
With another person holding the rear of the dishwasher
to keep it from tipping, open dishwasher door and place
towel over pump assembly and spray arm of dishwasher.
This will keep screws from falling into pump area when
you are securing dishwasher to cabinet.
Publicité
