Gima 25591 Manuel De L'utilisateur page 11

11
Temperature (°C)
T < 32.0
32.0 ≤ T ≤ 37.5
37.6 ≤ T ≤ 37.9
38.0 ≤ T ≤ 42.9
T > 42.9
Notice: Red Backlit is followed alarm temperature limit (Fever alarm) .
• Release the trigger and the reading will hold for approximately 15 seconds after
which the meter will automatically shut off
Note: Before shutting off, you can take further measurement.
• If the temperature goes above 109.2°F or 42.9°C, Hi will appear in the display.
If the temperature goes below 89.6°F or 32.0°C, Lo will appear in the display.
Notice: When surrounding temperature is lower than 10.0°C or higher
than 40.0°C, it's not allowed to measure of accuracy in not assured.
Object Temperature Measurements
• Press the trigger to switch the meter on with one beeper. The device performs
a brief self test: all elements of the display are shown for approx. 1 second.
Following a successful self test with backlit (Red-Orange-Green).
• Press the "B/O" button for "Object temp" for accurate measurements in the
range of 0.0 to 100.0°C (32.0 to 212.0°F).
• Hold the meter by its handle and point it toward the surface to be measured.
• Press the trigger to take a temperature reading. The temperature reading ap-
pears in the display.
• Release the trigger and the reading will hold for approximately 15 seconds after
which thermometer will automatically shut off.
Note: Before shutting off,you can take further measurements.
• If the temperature goes above 212°F or 100°C, "Hi" will appear in the display.
If the temperature goes below 32°F or 0°C, "Lo" will appear in the display.
Notice:
• The value under this Mode is object temperature instead of core temperature.
• The defaulted infrared from the real temperature according to different emissiv-
ity. For example,the reading on stainless steel will be obviously lower than the
actual temperature. BE CAUTIONS FOR SCALDING.
Data memory
• To review the logged data points, press the "Memory" button for one second
while the units is ON until "M" symbol shown on the display. Use the + or -
buttons to scroll through the stored measurements and memory locations. To
delete all memory data, pls take off the batteries when power on.
Temperature (°F)
T < 89.6
89.6 ≤ T ≤ 99.5
99.7 ≤ T ≤ 100.2
100.4 ≤ T ≤ 109.2
T > 109.2
ENGLISH
Fever Teller
Green
Green
Orange
Red
Red
Beep
Three beeps
One beep
One beep
Ten Rapid beeps
Three beeps