Porter Cable C1010 Manuel D'instructions page 17

CODE pOssIBLE CAUsE
16 Loose electrical connections
17 Possible defective motor.
18 Fuse blown, circuit breaker tripped
19 Tank pressure exceeds pressure switch cut-in pressure
pOssIBLE sOLUTIOn
Contact a Porter-Cable factory service center or a Porter-
Cable authorized service center.
Contact a Porter-Cable factory service center or a Porter-
Cable authorized service center.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch.
17